This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
cluster:194 [2021/06/07 07:41] hmeij07 [Update 12] |
cluster:194 [2021/08/18 08:58] hmeij07 [Update 12] |
||
---|---|---|---|
Line 346: | Line 346: | ||
* check permissions on cloned volume, not windows! | * check permissions on cloned volume, not windows! | ||
* NOTE: once had mnt/ | * NOTE: once had mnt/ | ||
- | * when cloning grant access to 192.168.0.0/ | + | * when cloning grant access to <del>192.168.0.0/ |
* NFS mount, read only | * NFS mount, read only | ||
* maproot '' | * maproot '' | ||
- | * Clone mounted on say '' | + | * Clone mounted on say '' |
* Restore actions by user | * Restore actions by user | ||
* Delete clone when done | * Delete clone when done | ||
Line 402: | Line 402: | ||
* At 100% stanby reboots, HA disables, file system ok | * At 100% stanby reboots, HA disables, file system ok | ||
* Check version on standby, Initiate Fail Over (interrupts file system) | * Check version on standby, Initiate Fail Over (interrupts file system) | ||
- | * Login, | + | * Login, |
- | * Logout/ | + | * Logout/ |
- | * Wait for HA to be enabled, | + | * when old active server boots "Pending Update" confirm to complete |
+ | * check version on new standby | ||
+ | |||
+ | ** 12.0 U4.1 ** | ||
+ | |||
+ | * ditto above, see major release upgrade below | ||
+ | * but old active did not come up, reset controller | ||
+ | * click on " | ||
+ | * hmm something about failed to connect failoverscratchdisk? | ||
==== HDD ==== | ==== HDD ==== | ||
Line 581: | Line 590: | ||
+ | ** 12.0-U5.1** | ||
+ | * standby reboot 5 mins | ||
+ | * fail over 1 min | ||
+ | * new standby "apply pending updates" | ||
+ | * this version went fine | ||
+ | Not applied yet ...\\ | ||
+ | While the underlying issues have been fixed, this setting continues to be disabled by default for additional performance investigation. To manually reactivate persistent L2ARC, log in to the TrueNAS Web Interface, go to System > Tunables, and add a new tunable with these values: | ||
+ | < | ||
+ | Type = sysctl | ||
+ | Variable = vfs.zfs.l2arc.rebuild_enabled | ||
+ | Value = 1 | ||
+ | </ | ||