This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
cluster:88 [2010/08/09 20:18] hmeij |
cluster:88 [2010/08/10 18:04] hmeij |
||
---|---|---|---|
Line 94: | Line 94: | ||
* 10 - kits: select Add, insert kit cd, wait, cycle through disks by kit, then No More Kits, then Finish (node reboots). | * 10 - kits: select Add, insert kit cd, wait, cycle through disks by kit, then No More Kits, then Finish (node reboots). | ||
- | Upon reboot check some command output: hostname, route, ifconfig, bhosts, bqueues | + | Upon reboot |
===== Step 3 ===== | ===== Step 3 ===== | ||
Line 131: | Line 131: | ||
* / | * / | ||
* 'mysql -u root' should work | * 'mysql -u root' should work | ||
- | * and/or python is missing a drive | + | * and/or python is missing a driver |
* yum install MySQL-python | * yum install MySQL-python | ||
* when addhost starts, select the *_BSS nodegroup created, and eth0 interface | * when addhost starts, select the *_BSS nodegroup created, and eth0 interface | ||
Line 137: | Line 137: | ||
* if you know blade will boot of network let it go, else F2, enter BIOS, set Boot menu to network first | * if you know blade will boot of network let it go, else F2, enter BIOS, set Boot menu to network first | ||
* once blade sends its eth0 IP over and receives kickstart file, move on to next blade | * once blade sends its eth0 IP over and receives kickstart file, move on to next blade | ||
- | * do 2-3 baldes | + | * do 2-3 blades |
- | * once the first blade is rebooted, enter BIOS, set boot menu to hard disk first | + | * once the first blade is rebooted, enter BIOS, set boot menu to hard disk |
- | * there' | + | * there' |
* once the last blade has fully booted of the hard disk quit addhost on installer node | * once the last blade has fully booted of the hard disk quit addhost on installer node | ||
* addhost will now push new files to all the members of the cluster using cfmsync | * addhost will now push new files to all the members of the cluster using cfmsync | ||
+ | |||
+ | Issue ' | ||
+ | |||
+ | ===== Step 4 ===== | ||
\\ | \\ | ||
**[[cluster: | **[[cluster: |