This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
cluster:194 [2020/04/27 11:15] hmeij07 |
cluster:194 [2020/04/28 09:02] hmeij07 |
||
---|---|---|---|
Line 86: | Line 86: | ||
* port 5 | * port 5 | ||
- | * plug in pin2usb cable | + | |
- | * set up mac, launch terminal, invoke screen | + | |
+ | * launch terminal, invoke screen | ||
+ | * screen / | ||
+ | * sysadmin/ | ||
+ | * ifconfig ehto | grep 'inet addr' or | ||
+ | * ipmitool -H 127.0.0.1 -U admin -P admin lan print | ||
+ | * ipmitool -H 127.0.0.1 -U admin -P admin lan set 1 ipaddr ... (etc + netmask + defgw) | ||
* to set initial ips/ | * to set initial ips/ | ||
- | * port 11 | + | * port 10 (if 12 option netcli boot menu does not show) |
* unplug console cable, plug in pin2serial cable | * unplug console cable, plug in pin2serial cable | ||
- | * set up windows laptop, launch hyperterminal | + | * set up windows laptop, launch hyperterminal, baud rate 115000 |
- | * 12 menu '' | + | * 12 menu '' |
* port 80->443, web site (with shell of '' | * port 80->443, web site (with shell of '' | ||
* gui | * gui | ||
* shell | * shell | ||
* all non-zfs commands are persistent across boots | * all non-zfs commands are persistent across boots | ||
- | * except ssh keys and permissions | + | * except ssh keys and directory |
==== HA ==== | ==== HA ==== | ||
Line 320: | Line 326: | ||
==== Update ==== | ==== Update ==== | ||
- | Changed | + | Change |
After its reboots, you will failover to it by **rebooting** the Active controller (the **current** WebUI). | After its reboots, you will failover to it by **rebooting** the Active controller (the **current** WebUI). | ||
- | This will failover to the updated 11.3-U2.1 controller. | + | This will failover to the updated 11.3-U2.1 controller |
- | From there, you would go to System > Update and do the same for the NOW passive controller. | + | From there, you would go to System > Update and do the same for the NEW passive controller. |
- | After that initiate failover back to primary. | + | After that initiate failover back to primary |
Enable HA, click icon | Enable HA, click icon |